Engineering Geology

Engineering Geology

Fractal analysis of seismicity parameters and crustal stress evaluation in eastern Iran

Authors
Mohammad Sadegh Sharifi
Saeed Zarei
Seyed Reza Mansouri
Abdullah Hussaini
Persian Gulf University
10.22034/JEG.2025.19.4.1020581
Abstract
The active tectonics of eastern Iran, resulting from the convergence of the Arabian and Eurasian plates and numerous active faults, has caused high stress concentration, as evidenced by major historical earthquakes such as those in Tabas (1978) and Bam (2003). This study aims to conduct a fractal analysis of seismicity parameters and investigate crustal stress heterogeneity in eastern Iran. To this end, an earthquake dataset of historical and instrumental events with Mw ≥ 4 (1900–2024) was compiled from the ISC and NEIC databases. After filtering and declustering, the data were analyzed using ZMAP and ArcGIS. The b-value (an indicator of stress level and the probability of large earthquakes), the D-value (the geometrical complexity of faulting), and the D/b ratio were calculated simultaneously and mapped spatially. The results show that the b-value ranges from 0.8 to 1.1, and the D-value ranges from approximately 1.6 to 2.3. Regions with low b-values and high D-values, especially along the Nehbandan and Dasht-e Bayaz faults, indicate high stress concentrations and an elevated likelihood of larger earthquakes. The total seismic moment of the cataloged earthquakes is estimated at 3.5×10²³ N·m, yielding an average annual seismic moment rate of 2.7×10¹⁶ N·m/yr (calculated by averaging over the available catalog years). The D/b ratio, regarded as an index of stored energy and stress heterogeneity, exceeds two in these zones and exhibits a strong correlation with areas of a high rate of seismic moment release. This pattern implies that an increase in fault geometrical complexity coupled with a decrease in the b-value signals the crust’s approach to the rupture threshold. Thus, by emphasizing the significance of the D/b ratio, the present findings offer a quantitative approach to mapping stress states, fault structures, and the potential for significant earthquakes in eastern Iran.
Keywords
Fractal
b-value
D-value
D/b ratio
Seismic Moment Rate
seismicity
Active Faults of Eastern Iran
Abdelrahman, K., & Ali, S. M. (2024). Analysis of the fractal dimension, b-value, slip ratio, and decay rate of aftershock seismicity following the 6 February 2023 (Mw 7.8 and 7.5) Türkiye earthquakes. Fractal and Fractional, 8(5), 252.
Asghari, H., Khatib, M. M., Gholami, E., & Bagheri, S. (2024). Analysis and comparison of paleo stress variations using structural pattern and slip data inversion methods in the southern part of the East Iranian Tectonic Belt. Journal of Tectonics.
Barton, C. C. (1988). Fractal analysis of scaling and spatial clustering of fractures. Geophysical Research Letters, 15(5), 375–378.
Berberian, M., Jackson, J. A., Qorashi, M., Talebian, M., Khatib, M., & Priestley, K. (2000). The 1994 Sefidabeh earthquakes in eastern Iran: Blind thrusting and bedding-plane slip on a growing anticline, and active tectonics of the Sistan suture zone. Geophysical Journal International, 142(2), 283–299.
Liu, C., & Kagan, Y. Y. (2025). The characteristics of seismicity in East Anatolian Fault Zone. Journal of Seismology, 29(1), 45–68.
Grassberger, P., & Procaccia, I. (1983). Measuring the strangeness of strange attractors. Physica D, 9(1–2), 189–208.
Gutenberg, B., & Richter, C. F. (1944). Frequency of earthquakes in California. Bulletin of the Seismological Society of America, 34(4), 185–188.
Hanks, T. C., & Kanamori, H. (1979). A moment magnitude scale. Journal of Geophysical Research: Solid Earth, 84(B5), 2348–2350.
Hooker, S. J., & Johnson, D. A. (1995). Fractal dimensions of fractures in carbonate reservoirs. Journal of Structural Geology, 17(7), 993–1003.
Johnston, A. C. (1996). Seismic moment assessment of earthquakes in stable continental regions — III. New Madrid 1811–1812, Charleston 1886 and Lisbon 1755. Geophysical Journal International, 126(2), 314–344.
Kagan, Y. Y. (2002). Seismic moment-frequency relation and seismic energy release. Geophysical Journal International, 149(2), 319–329.
Kanamori, H. (1977). The energy release in great earthquakes. Journal of Geophysical Research, 82(20), 2981–2987.
McCaffrey, R. (2005). Block kinematics of the Pacific–North America plate boundary in the southwestern United States from inversion of GPS, seismological, and geologic data. Journal of Geophysical Research: Solid Earth, 110(B7).
Mohajer-Ashjai, A. & Nowroozi, A.A. )1978(, Observed and probable intensity zoning of Iran.Tectonophysics, 49, 149-160.
Öncel, A. O., Wilson, T. H., & Nishizawa, O. (2001). Size scaling relationships in the active fault networks of Japan and their correlation with Gutenberg–Richter b-values. Journal of Geophysical Research: Solid Earth, 106(B10), 21827–21841.
Perez, R., & Tuckwell, G. (1993). Fractal geometry and the distribution of fractures in reservoirs. Journal of Petroleum Science and Engineering, 10(4), 299–311.
Ramesh, A. (2025). Precursory seismic patterns preceding major earthquakes: A case study from Northern Himalayas. Tectonophysics, 850, 229756.
Scholz, C. H. (1968). The frequency-magnitude relation of microfracturing in rock and its relation to earthquakes. Bulletin of the Seismological Society of America, 58(1), 399–415.
Scholz, C. H. (2019). The mechanics of earthquakes and faulting. Cambridge university press.
Slemmons, D. B. (1982). Determination of design earthquake magnitudes for microzonation. In Proceedings of the Third International Earthquake Microzonation Conference (pp. 119–130).
Soltani, M., & Tavakoli, B. (2013). Fractal analysis of fractures in the Zagros region, Iran. Geophysical Journal International, 192(2), 667–678.
Tatar, M., & Javad, A. (2012). The role of tectonics in the seismic activity of the Zagros and Alborz Mountain ranges, Iran. Journal of Geophysical Research: Solid Earth, 117(B6), B06402.
Turcotte, D. L. (1997). Fractals and chaos in geology and geophysics (2nd ed.). Cambridge University Press.
Walker, R., Jackson, J., & Parsons, B. (2011). Active tectonics and earthquakes in central and eastern Iran. Tectonics, 30, TC5010.
Wiemer, S., & Wyss, M. (2000). Minimum magnitude of completeness in earthquake catalogs: Examples from Alaska, the western United States, and Japan. Bulletin of the Seismological Society of America, 90(4), 859–869.
Wilson, A., Öncel, A. O., & Dixon, T. H. (2002). Space-time correlations of seismotectonic parameters: Examples from Japan and from Turkey preceding the İzmit earthquake. Bulletin of the Seismological Society of America, 92(1), 339–349.
Yadav, R. B. S., Gahalaut, V. K., Chopra, S., & Shan, B. (2012). Tectonic implications and seismicity triggering during the 2008 Baluchistan, Pakistan earthquake sequence. Journal of Asian Earth Sciences, 45, 167–178.
Zarei, S., Khatib, M. M., Zare, M., & Mousavi, S. M. (2019). Evaluation of seismicity triggering: Insights from the Coulomb static stress changes after the 30 August 1968 Dasht-e-Bayaz earthquake (Mw = 7.1), Eastern Iran. Geotectonics, 53, 601–616.
Zarifi, Z., Nilfouroushan, F., & Raeesi, M. (2013). Crustal stress map of Iran: Insight from seismic and geodetic computations. Pure and Applied Geophysics, 171, 1219–1236.