Volume 5, Issue 2 (4-2012)                   2012, 5(2): 1193-1216 | Back to browse issues page

XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Sorosh A, Hashemi tabatabaee S, ghalandarzadeh A. Assessment of particle breakage in rockfill materials using triaxial testing. Journal of Engineering Geology 2012; 5 (2) :1193-1216
URL: http://jeg.khu.ac.ir/article-1-368-en.html
Abstract:   (5884 Views)
All rockfill materials subjected to stresses above the normal geotechnical ranges exhibit considerable particle breakage. Particle breakage and crushing of the large particles to smaller ones result in a lower strength and higher deformability. The breakage of particle that is observed in the large scale triaxial tests, is usually expressed quantitatively by the Marsal breakage index, . This paper presents a method for calculating at any axial strain level in the large triaxial tests. The model used Rowe’s minimum energy principle ratio. The key parameter in modeling , is the friction angle which excludes dilation and breakage effects, . The results indicate that the internal friction angles at confining pressure equal and less than 200 kPa at the constant volume state is a unique value. Moreover, there is a linear relationship between the variation of energy spent on particle breakage to Marsal Breakage index with confining pressure, at failure axial strain.
Full-Text [PDF 429 kb]   (2485 Downloads)    
Type of Study: Case-Study | Subject: En. Geology
Accepted: 2016/10/5 | Published: 2016/10/5

Add your comments about this article : Your username or Email:
CAPTCHA

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2024 CC BY-NC 4.0 | Journal of Engineering Geology

Designed & Developed by : Yektaweb